Digifast DX2 Instructions D'utilisation page 17

All manuals and user guides at all-guides.com
Accessories
DX2 Operation instruction
The working mode is separated to manual and automatic modes.
1. DX2 is equipped with a power-off memory function, it will enter the
previous working mode by default.
2. Mode switch: press the button for 2 seconds to switch working mode
(blue for automatic mode, green for manual mode).
3. Under manual mode, the power is off by default. The power will be
supplied after turning on the switch.
4. Under manual mode, the power will be supplied after inserting an
NVMe SSD.
5. Under automatic mode, the power will be off when there is no device
detected.
6. Under automatic mode, there is a delay opening function. To protect
the device, the power-on time will be delayed when inserting a device.
7. Under automatic mode, you still can choose if you would like to toggle
the power manually.
8. Regardless of mode, the power will turn off automatically if the device
is unplugged.
9. When the mode is switched, if there is an NVME SSD on the docking
base, the power supply will perform an on/off conversion once at the
same time.
docking*1 PCS
USB3.1 C-C cable(L=15cm)*1PCS
USB3.1 A-C cable(L=15cm)*1PCS
Heatsink set*1
17