T-ONE 118514 Directives De Montage

Installation Instructions
Directives de montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
Aveo
READ THIS FIRST:
Read and follow all vehicle warnings and
installation instructions before beginning installation.
Wear safety glasses and use all safety precautions
during installation.
LISEz CECI En PREmIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l'installation. Durant
l'installation, veiller à toujours porter des lunettes
de protection et respecter les mesures de sécurité.
LEA ESTO PRImERO:
Lea y siga todas las advertencias e instrucciones
de instalación del vehículo antes de empezar la
instalación. Use gafas de seguridad y todas las
precauciones de seguridad durante la instalación.
118514-037 Rev. A
ENGLISH
TOOLS REQUIRED:
T est-probe, Trim Panel Remover, Drill (3/32"
Drill Bit), Philips Head Screwdriver
1. Open trunk and remove threshold panel.
Partially remove the corner felt trunk liner, on
both sides, exposing the vehicle's taillight wiring
harness. de
2. On the driver and passenger sides of the vehi-
cle, locate the vehicle's taillight wiring harness.
The taillight wiring harness will have a connec-
tion point, on both sides, matching the ends of
the T-Connector. f Separate this connector,
being careful not to break the locking tabs. All
connector surfaces should be clean and free of
dirt.
3. On the driver's side, insert the T-Connector end,
with the yellow wire, between the vehicle wiring
connectors and lock into place. Be careful not to
damage the locking tabs and be sure that con-
nectors are fully inserted with locking tabs in
place.
4. Route the T-Connector end, with the green wire,
under felt trunk liner to passenger side vehicle
taillight wiring harness. Repeat step 3 for the
passenger's side using the T-Connector contain-
ing the green wire.
5. Locate a suitable grounding point near the con-
nector. Drill a 3/32" hole and secure the white
wire using the eyelet and screw provided. Do
not drill into any exposed surfaces.
d
e
08/27/2010
CAUTIOn
Verify what is behind any surface prior to
drilling to avoid damage to the vehicle and/or
personal injury. Do not drill into any exposed
surfaces.
WARnInG
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer once
installed. For initial test, reset vehicle electrical
system by temporarily removing the key from
the ignition.
6. Behind the taillight assembly on the Driver's
side, clean a flat area using a mixture of rubbing
alcohol and water. Mount the black box in this
area using the double-sided tape provided.
7. Route the 4-Flat from below the threshold plate
into trunk. Store there when not in use.
8. Reinstall felt trunk liner, threshold, and other
items removed during installation, being careful
not to pinch or cut the wires.
WARnInG
Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side (2.1 amps)
• Max. tail lights: (7.5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
f
g