Black & Decker LE3 Mode D'emploi page 5

d. Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
If contact accidentally occurs, flush with
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from
the battery may cause irritation or burns.
6. Service
a. Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
Additional power tool safety warnings
Warning! Additional safety
warnings for torches
• Never attempt to remove or replace any
parts other than those specified in this
manual.
• Do not operate without the lens in place
or with a damaged lens.
• Never look directly into the light or shine
the light into another persons eyes.
Warning! Fire hazard.Do not
operate worklight or charger near
flammable liquids or in gaseous or
explosive atmospheres. Internal sparks may
ignite fumes causing personal injury.
• Do not expose light or charger to wet or
damp areas. Do not expose light or
charger to rain or snow.
• Do not wash light or charger with water
or allow water to get inside light or
charger. Do not submerge light in water
at any time.
Caution! When not in use, place
tool on its side on a stable surface
where it will not cause a tripping
or falling hazard. Some tools with large
battery packs will stand upright on the
All manuals and user guides at all-guides.com
battery pack but may be easily knocked
over.
• Never view directly with optical
Residual risks
Additional residual risks may arise when
using the tool which may not be included in
the enclosed safety warnings. These risks
can arise from misuse, prolonged use etc.
Even with the application of the relevant
safety regulations and the implementation
of safety devices, certain residual risks can
not be avoided. These include:
• Injuries caused by touching any
• Injuries caused when changing any parts,
• Injuries caused by prolonged use of a
• Impairment of hearing.
• Health hazards caused by breathing dust
Labels on tool
The following pictograms are shown on the
tool:
manual.
instruments into the light source.
rotating/moving parts.
blades or accessories.
tool. When using any tool for prolonged
periods ensure you take regular breaks.
developed when using your tool
(example:- working with wood, especially
oak, beech and MDF.)
Warning! To reduce the risk of injury,
the user must read the instruction
Position 1: 13 LED Round Lamp On
Position 2: 18 LED Panel Lamp On
ENGLISH
5