Black & Decker BDJS350 Mode D'emploi page 4

ENGLISH
When using this unit in proximity to the vehicle's battery
and engine, stand the unit on a flat, stable surface, and
be sure to keep all clamps, cords, clothing and body
parts away from moving parts of the vehicle.
This appliance contains a sealed lead-acid battery. It is
recommended that the appliance is laid flat during
storage, use, and recharging.
Warning! Explosive gas may be vented from the lead acid
batteries when charging and under extreme conditions
battery leakage may occur. Ensure the area is well ventilated
when conducting jump starting and charging procedures.
Do not charge the appliance using the 12V connector
when the vehicle is occupied. Ensure the area is well
ventilated.
To reduce the risk of electric shock, disconnect the
appliance from any power source before attempting
maintenance or cleaning. Turning off controls without
disconnecting the appliance will not reduce this risk.
Make sure the appliance is disconnected from all
charging power sources before beginning the jump start
procedure.
Never attempt to use the ac charger and dc charging
connection simultaneously.
Additional safety instructions for batteries and chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not store in locations where the temperature may
exceed 40°C.
Charge only at ambient temperatures between 4°C and
40°C.
Charge only using the chargers provided with the
appliance.
When disposing of batteries, follow the instructions
given in the section "Protecting the environment".
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe
the liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid is a diluted sulphuric acid and
may cause personal injury or damage to property. In case of
skin contact, immediately rinse with water. If redness, pain or
irritation occurs seek medical attention. In case of eye
contact, rinse immediately with clean water and seek
immediate medical attention.
4
All manuals and user guides at all-guides.com
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the battery
in the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
Do not probe the charger.
The battery must be placed in a well ventilated area when
charging.
Fail-safe isolating transformer. The mains supply is
electrically separated from the transformer output.
130 o C
The charger automatically shuts off if the ambient
temperature becomes too high. As a consequence
the charger will be inoperable. The charging base
must be disconnected from the mains supply and
taken to an authorised service centre for repair.
Read all of this instruction manual carefully.
This appliance is intended for indoor use only
Electrical safety
This appliance is double insulated; therefore no
earth wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.