Nokia 6210 Navigator Mode D'emploi page 5

cup and the windscreen. Check that
the suction cup is firmly attached.
To detach the mounting device from
the windscreen, carefully push the
Set to the desired position
Do not adjust the mounting device
while driving.
To adjust the top of the mounting
device, loosen the two screws in the
middle of the mounting device, turn
the top to the desired position, and
tighten the screws (5). Ensure that the
Mount the mobile holder
To attach the Nokia Mobile Holder
CR-97 to the mounting device,
remove the protection plate with the
Nokia text from the holder, use a
screwdriver to attach the holder to the
mounting device with the supplied
All manuals and user guides at all-guides.com
locking lever toward the top of the
mounting device (3), and pull the
strap located on the edge of the
suction cup (4).
top of the device is firmly locked into
place.
To adjust the mounting plate at the
top of the mounting device, loosen the
screw below the plate, turn the plate
to the desired position, and tighten
the screw (6).
screw, and replace the protection
plate (7).
To place your mobile device into the
holder, press the release buttons at
the sides of the holder (8), and insert
the lower part of the device into the
ENGLISH