Uni-bond E-917AA Manuel D'installation

Wire Colour Function
Red Power
Black Ground
Yellow Pattern Selection
Surface Mount: 2 Holes @ 4 " centres •
1.0 Pattern Selection
- Tap yellow wire to red wire (Power) momentarily to change patterns (see Flash Patterns)
To return to pattern NO. 1, touch yellow wire to red wire (Power) quickly 3 times.
-
1.1 Flash Patterns
NO.
1 Steady Light on All
2 Simultaneous Single Flash (2Hz)
3 Simultaenous Double Flash (2Hz)
4 Simultaneous Quad Flash (2Hz)
5 Random Flash
6 Alternating Double Flash
7 Alternating Quad Flash
8 Simultaneous Single Flash
9 Simultaneous Double Flash
10 Simultaneous Quad Flash
11 Simultaneous Quint Flash
12 Simultaneous Ultra Flash
13 Simultaneous Single Flash / Quad Flash
14 Steady Light on 3 Diodes & Double Flash (2Hz) on 3 Diodes
2.0 Suggested Switch Connection
Battery Ground
Ground
Power
Pattern Selection
For more information, visit our website at: www.unibondlighting.com
INSTALLATION MANUAL
Light should be fused with 5 Amp Fuse (
Flash Patterns
(switches sold separately)
Connect To
+12/24/36 VDC (Power)
-
(Ground)
+12/24/36 VDC (Power)
SAE
J845 Class 1
J845 Class 1
J845 Class 1
J845 Class 1
J845 Class 1
From Battery Positive
Jumper Wires
Switch #1
ST307
(OFF-ON-Momentary ON)
For Synchronizing 2+ Lights
(
refer to Synchronization Manual
Last Updated: 09/23/2022
E-917AA
)
ATM05 sold separately
)