Publicité
Les langues disponibles
Les langues disponibles
Keyhole
1
/
"
9
16
Holes
for Wall
Mounting
Case Style "A" Back
Code and Tune Settings
Note: Most installations will not require you to change any jumpers on
your chime and push button.
The push button and chime communicate by using a code that can be changed
by removing and/or adding jumpers on both the push button and chime. The
code is factory set; however, there are 128 selectable codes that allow you to
expand your system and prevent outside interference. Other wireless products
may cause interference and the system may not function properly. Follow the
instructions below for setting a new code.
1. Open the cases and locate the jumpers on both the push button and chime
(See illustration on page 3).
2. The push button and chime both have eight different jumper locations. The
jumper positions 1 through 7 are used for setting the code.
3. To change the code, add and/or remove jumpers as needed. It is recom-
mended to only change one jumper at a time and then check to see if system
is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly
the same for both the push button and chime for this system to function.
Attach back of case to door jamb or wall. Snap
front of push button on.
When attaching push button using double sided
tape, make sure the surface of the door jamb or
wall is clean.
Case Style "A": Chime can be mounted by using
2 holes in the back of case, or by using 1 screw
with keyhole.
Case Style "B": Chime can be mounted by using 1
screw with keyhole (see illustration on page 1).
Case Style "A": Snap front of chime case on.
Start with top edge of case aligned with the top
of back plate.
Case Style "B": Snap battery access door firmly
in place before mounting (See illustration on
page 1).
Code Settings
-2-
595-5551-10
Publicité
