Publicité
Les langues disponibles
Les langues disponibles
Carbon Filter
A built-in carbon
Internal Fan
This is an air-cooled unit equipped with an internal fan that maintains a consistent internal temperature.
Note: The carbon
er should be replaced every 3-6 months depending on the unit's exposure level to
odor. If the unit is placed in a kitchen, regular replacement every three (3) months is ideal.
Carbon Filter Replacement Part #: Z0F-C007
Tip: Gather the model and serial number from the product label and write them down before installing the
wine cooler.
Installing Your Wine Cooler
The wine cooler should be installed in accordance with local electrical code requirements. It
should also be placed in a
will weigh
Before you plug the wine cooler into a power supply, be sure to let it stand upright for at least 24
hours to allow the compressor's oils to se e.
Warning: Use two or more people to move and install the wine cooler. Failure to do so can result
in back or other injury. Carefully remove the packaging materials. Remove any shipping tape and glue from
your wine cooler before using. Do not use sharp instruments, rubbing alcohol,
or abrasive cleaners to remove tape or glue. These products can damage the surface of your wine
cooler.
Important: Do not remove any safety, warning, or product infor
cooler.
er protects your beverages by ac
that is strong enough to support its total weight, keeping in mind that it
more when fully loaded than when empty.
as a natural barrier against harmful odors.
labels from your wine
3
e
Publicité
