Cycles - Inglis IFR82000 Guide D'utilisation Et D'entretien

Automatic Cycles
When you are using the Auto Moisture Sensing Cycle, two metal
strips (sensors) located on the dryer baffles determine the
dryness of the load. The metal strips help detect the amount of
moisture left in the clothes as they pass. When there is moisture
left in the clothes, the machine will continue to run. As clothes
begin to dry, the amount of water left in the clothes decreases,
and the timer advances through the remainder of the cycle. When
the selected dryness level is reached, the dryer goes into a cool
down period of up to 15 minutes.
Automatic cycles may be used for most loads. Automatic cycles
give the best drying results in the shortest time. Drying time
varies according to the type of fabric, size of the load and
dryness setting.
After drying a load, check the dryness.
If the load is drier than you like, select a setting closer to Less
Dry the next time you dry a similar load.
If a load is not as dry as you like, complete drying using a
Timed cycle. Select a setting closer to More Dry the next time
you dry a similar load.
See following table for recommended cycles and temperature
settings.
Fabric Type
REGULAR
Heavy cottons and denims
Cottons and linens
SYNTHETICS
White and colorfast
permanent press
White and colorfast items
that require ironing
Polyester/acrylic blends,
rayon, acetate
Washable silk and nylon
Timed Dry
Use this cycle to get up to 60 minutes of heated drying time or to
complete drying if items are still damp after the automatic cycle.
Timed Dry is also useful for:
Heavyweight items and work clothes that require a long
drying time.
Lightweight items, such as lingerie, blouses and knits that
require a short drying time.

Cycles

Cycle Temperature
Setting
More Dry Normal
Normal Normal
Normal Low
Less Dry Low
Delicates Low
Delicates Low
See following table for recommended cycles and temperature
settings.
Fabric Type
Heavy cottons and denims
Cottons and linens
White and colorfast
permanent press
White and colorfast items
that require ironing
Polyester/acrylic blends,
rayon, acetate
Washable silk and nylon
End of Cycle Signal
The dryer sounds a signal to let you know when the cycle is
complete. The signal is not adjustable and cannot be turned off.
The signal is helpful when you are drying permanent press,
synthetics, and other items that should be removed promptly at
the end of the cycle.
Anti-Wrinkle
Anti-Wrinkle helps avoid wrinkles that form when clothes are not
removed promptly at the end of a cycle. Anti-Wrinkle tumbles the
load every minute until the cycle knob is set to the Stop position
or the dryer door is opened.
During Anti-Wrinkle, the End of Cycle Signal will sound until the
cycle knob is set to the Stop position or the dryer door is opened.
Time Temperature
(minutes) Setting
60 Normal
40 Normal
40 Low
40 Low
40 Low
40 Low
13