Publicité
Liens rapides
Publicité
Manuels Connexes pour Greemotion Sandor GM-1013
Sommaire des Matières pour Greemotion Sandor GM-1013
- Page 1 GM-1013 Sandor Double Swing Chair...
- Page 2 SAFETY INSTRUCTIONS AND WARNINGS: INDICACIONES DE SEGURIDAD Y ADVERTENCIAS: • The product is to be used exclusively for its intended purpose. • Utilice el artículo exclusivamente conforme a las instrucciones de uso del • Regularly check the condition and functionality of the product. If you notice mismo.
- Page 3 PARTS 2 pcs 2 pcs 2 pcs 2 pcs 2 pcs 4 pcs 1 pc 1 pc 1 pc 2 pcs 1 pc 1 pc 2 - 11...
- Page 4 PARTS 2 pcs 1 pc 1 pc 1 pc 1 pc 1 pc HARDWARE 18 pcs 2 pcs 16 pcs 8 pcs M8 x 75mm M8 x 45mm M8 x 40mm 8 pcs 8 pcs 4 pcs 4 pcs 3 - 11...
- Page 5 HARDWARE 1 pc 1 pc ASSEMBLY INSTRUCTIONS Insert leveler (7) into Legs (B, C). Do not fully tighten. 4 - 11...
- Page 6 ASSEMBLY INSTRUCTIONS Tool Connect Leg Connector (A) between Legs (B, C) and secure with bolt (2). Keep Leg (C) on the same as as cap (4). Add caps (4) when bolts are fully inserted. Secure Legs (B, C) at intersection point with bolt (1). 5 - 11...
- Page 7 ASSEMBLY INSTRUCTIONS Tool Connect Support Beams (D, E) with Bracket (F). Secure with bolt (2). Add caps (4) once bolts are fully inserted. Tool Secure Support Beams (D, E) to Leg (B) and Leg Connector (A) with bolt (2). Add caps (4) once bolts are fully inserted. Insert bolt (3) through tops of Legs (B, C) and secure with ring (5).
- Page 8 ASSEMBLY INSTRUCTIONS Connect Canopy Front Frames (K-1, K-2). Add Frame End (M). Connect Canopy Back Frames (N-1, N-2). Insert Canopy Frames (K, N) through ends of Canopy Cover (P). 7 - 11...
- Page 9 ASSEMBLY INSTRUCTIONS Attach Canopy (P) to Legs (B, C). Frame End (M) attaches to Leg (B). Clip both ends of swing rope (8) with a carabiner (9). Attach one end to each ring (5). Let ropes hang. 8 - 11...
- Page 10 ASSEMBLY INSTRUCTIONS Lay Seat Cover (Q) flat. Fold arm flaps in. Insert Seat Frame (H) through the center. Insert Seat Frame (I) through top end. Ensure visible holes on Seat Frame (I) are facing down. Insert Seat Frame (G) on arm flap end. Insert Arm Frames (J) through Seat Cover (Q).
- Page 11 ASSEMBLY INSTRUCTIONS back Connect Arm Frame (J) with top Seat Frame (I). Connect Arm Frame (J) with center Seat Frame (H). Connect Arm Frame (J) to bottom Seat Frame (G). 10 - 11...
- Page 12 ASSEMBLY INSTRUCTIONS Tool Secure ends of Arm Frame (J) with bolt (3) and ring (5). Tie Seat Cover (Q). Latch hanging carabiners (8) to seat frame rings (5). 11 - 11...