Ditel KOS Serie Guide D'installation Rapide page 16

TECHNICAL SPECIFICATIONS
UNIVERSAL INPUT
Current ..................................................................0/4-20mA
Impedance .........................................................................51Ω
Auxiliary excitation ..............................................12V @ 20mA
Voltage ....................................................................... 0-10V
mV ....................................................................... 0 a +60mV
Impedance ....................................................................... 1MΩ
RTD Pt100, Pt500, Pt1000, Ni100, PTC, NTC
Thermocouple (J, K, R, S, T, B, E, N)
Potentiometer .....................................................6kΩ to 150kΩ
ACCURACY
Overall maximum error .................................................. 0.3%
Linearity error ................................................................ <0.1%
Thermal drift ............................I = 0.8µA/ºC, V = 0.3mV/ºC
OUTPUTS 1 and 2
Alarm relay (programmable software ) ......SPST 5A @ 230VAC
OUTPUT 3 (OPTIONAL)
SSR ............................................................ (max) 12V @ 30mA
ISOLATION
Input / Output / Power Supply ................................ 1500VAC
POWER SUPPLY
Universal ........................................................24 a 230 VAC/DC
ENVIRONMENTAL CONDITIONS
Operating temperature .................................... -15ºC to +65ºC
Storage temperatura ......................................-40ºC to +85ºC
Warm-up time .....................................................................5 m
Temperature coefficient .............................................50ppm/ºC
FORMAT
Protection .......................................................................... IP20
Material ..........................................Extinguishing plastic PCABS
Weight ..............................................................................180g
UL Combustibility .................................................................. V0
Mounting .............................................................. rail EN50022
WIRING
Screw terminals M3 ............................................. torque 0.5Nm
Connection cable ............................................≤2.5mm² (12AWG
DIMENSIONS
DISEÑOS Y TECNOLOGÍA, S.A.
Xarol, 6B P.I. Les Guixeres
08915 Badalona (Barcelona) - Spain
Potentiometer
Rés Variable
Thermocouple
DIGITAL
INPUT
POWER SUPPLY
OUTPUT
OUTPUT
CE Conformity.
Directives
Standarts
ATTENTION: If this instrument is not installed and used in accordance with
these instructions, the protection it provides against hazards may be
impaired.
To meet the requirements of EN 61010-1, where the unit is permanently connected
to the main power supply, it is mandatory to install a circuit-breaking device easily
accessible to the operator and clearly marked as a disconnect device.
According to 2012/19/EU Directive, You cannot dispose of it at the end
of its lifetime as unsorted municipal waste. You can give it back,
without any cost, to the place where it was adquired to proceed to its
controlled treatment and recycling.
Tel. +34 933 394 758
Fax +34 934 903 145
Email: comercial@ditel.es ; web: www.ditel.es
WIRING
ACCESSORY
SOURCE
SINK
EMC 2014/30/EU LVD 2014/35/EU
EN 61000-6-2
EN 61010-1
EN 61000-6-3
OPTIONAL
20230710