Hahn 40807 Assemblage

40807 CHROME WALL RACK
ASSEMBLY INSTRUCTIONS
Contents
4 x 6mm support arm screw
2 x 28mm hanging pole screw
5 x 25mm wall screw
1 x rack frame
1 x rack grid
1 x hanging pole
2 x support arm
12 x 's' hook
Assembly
Remove all packaging and check contents.
Remove the grid from the rack frame.
Attach the two support arms to the outside edges of the frame using 6mm
support arm screws. The triangular fixing points at the base should be
facing inwards.
Position the hanging pole between the two support arms and fasten at
each end using 28mm hanging pole screws.
Attach to wall using the four hanging points, two in the rear of the rack
frame and one at the base of each support arm. Please ensure that
fixings used are appropriate to the wall type and expected loading on the
rack.
Place the grid in the frame and 'S' hooks on the hanging bar.
IMPORTANT:
The maximum permissible load weight of this rack is 20kg / 44lbs.
Always try to evenly distribute the hanging of items; this will helps spread
the load.
The Old Grain Store
Unit 6 Hullockpit Hill
Newnham
Nr Baldock
Hertfordshire SG7 5DP
England
www.hahn-kitchnenware.com