GE Quirky PIVOT POWER GENIUS Mode D'emploi page 3

GETTING STARTED
1 Download and install the Wink app on your
mobile device as outlined in the Quick
Start Card. The app will enable a Wi-Fi®
connection between your mobile device
and Pivot Power Genius.
2 Plug Pivot Power Genius into a grounded
wall outlet and press the power button to
turn it ON. When the power strip is ON,
the main power indicator light will glow.
DO NOT plug devices into any of the
outlets at this time.
When the power strip is turned ON, the
two regular outlets are always ON. The
two smart outlets are defaulted to OFF.
3 Open the Wink app. Follow the app's
instructions to connect to your Pivot
Power Genius.
Your mobile device connects by sending
light pulses into a sensor on your Pivot
Power Genius. It is best to do this in a
dimly lit environment.
4 Once you've connected, you can plug
devices into Pivot Power Genius
Note: DO NOT OVERLOAD the power strip.
ONLY connect the device to a grounded outlet.
DO NOT connect to an ungrounded outlet.
DO NOT extend or daisy chain with other
power strips or adapters.
PIVOT POWER® GENIUS | USER MANUAL | V-O2 | PAGE 3
USING PIVOT POWER GENIUS
You can use Pivot Power Genius to:
1 Adjust and rotate each outlet to fit
designated areas and/or large plugs
and power adapters.
2 Turn ALL outlets ON or OFF using the
main power button.
3 Control both smart outlets:
By manually turning each outlet's switch
ON/OFF from your Wink App or using
the buttons on the side of the power strip.
By scheduling each smart outlet to turn
ON/OFF via the Wink app. Use it to set
notifications for Wi-Fi® or power status.
Note: LEDs next to each smart outlet indicate
whether that outlet is ON or OFF.
ON/OFF button for each smart outlet
located on the side of the power strip.
TROUBLESHOOTING
If the Wi-Fi® connection has been lost,
any scheduled timers may not execute
depending on the outage time. Re-connect
the Wi-Fi® network.
If the Wink app has lost control of the
smart outlets, it may be that Pivot Power
Genius has lost its connection to the Wi-Fi®
network. Try turning the power strip OFF
then ON again to restore its connection.
If you experience a power outage, power
will cease to ALL outlets and the Wink
app connection will be lost. When power
is restored, check the main power button
to ensure the power strip is ON to regain
connection.
If you can't control the smart outlets from
a different mobile device, ensure you are
using the same account information within
the app.
QUESTIONS?
For service and support or tutorials, visit
http://www.quirky.com/wink/pivotpowergenius/faq,
email us at questions@quirky.com or
call 1-866-5QUIRKY.