Worldcast Systems APT Mobile SureStreamer Mode D'emploi page 4

English version
2. Preparing the accessories
2.1 Setting up the modems
The modems are preconfigured and
will automatically connect to your
provider's network when the SIM
cards are inserted, and the battery is
connected.
The modems are located in the bag.
Unzip the all-around zipper on the
rear of the bag to access the
modems.
Fold the modems out of the mold so
that you do not have to remove the
cables. If the Eth cable is unplugged,
put it back in the yellow LAN
connector.
Open the SIM card slots and insert the SIM card as shown in the pictures.
Figure 3: Overview of the Micro SIM card installation
After you have inserted the SIM cards, close the flaps and put the modems back into their slots.
Make sure the SIM cards have no PIN code.

When the modems are operational, all LED indicators are green.
If your modem does not automatically connect to the provider's network, please refer to the
instructions in Configuration guide.
4
All manuals and user guides at all-guides.com
Figure 2: Shows the molded foam with the
modems on the underside of the
SureStreamer, one modem is pulled out