Télécharger Imprimer la page

Danby Products Silhouette Professional DBC031D1BSSPR Guide D'utilisation Et Soins De Propriètaire page 13

Publicité

Les langues disponibles

Les langues disponibles

Troubleshooting
Occasionally, a problem is minor and a service call may not be necessary- use this troubleshooting guide for a possible
solution. If the unit continues to operate improperly, call an authorized service depot or our Toll Free Number 1-844-455-
6097 for assistance.
PROBLEM
No power
Cabinet temperature is too
high
Alarm beeping and "HI" is
displayed on the control
panel
Alarm beeping and "LO"
is displayed in the control
panel
Condensation on the cabi-
net and/or doors
All manuals and user guides at all-guidesbox.com
POSSIBLE CAUSE
A fuse in your home may be
blown or the circuit breaker
tripped
Power surge
Plug not fully inserted into wall
outlet
Temperature is set too high
Door is not shut properly or
opened excessively
Exhaust vent is obstructed
Recently added a large quantity of
warm beverages to the cabinet
Recently added a large quantity
of warm bottles or cans to the
cabinet
The door is not closed tightly
System leak, evaporator fan fail-
ure or compressor fan failure
Sensor failure, evaporator tem-
perature is too low
High humidity conditions in the
home
Door not shut properly or opened
excessively
10
SOLUTIONS
Replace fuse or reset circuit
breaker
Unplug the beverage centre, wait
a few seconds and then plug it
back in
Make sure the 3-prong plug is
fully inserted into the outlet
Verify the temperature control
setting, adjust if neccessary
Ensure that the door is fully
closed and that the gasket is
sealing against the cabinet. Open
the doors only as needed and for
short periods of time
Verify there is nothing blocking
the front mounted exhausting vent
Limit the quantity of warm bev-
erages being introduced to the
cabinet at the same time. Attempt
to stagger the load introduction if
possible
Limit the quantity of warm items
being introduced to the cabinet
Be sure the door is closed tightly
Contact a service centre, to stop
the beeping, unplug the unit
Contact a service centre, to stop
the beeping, unplug the unit
The condensation will subside
once humidity conditions return to
normal
Ensure that the door is fully
closed and that the gasket is seal-
ing against the cabinet. Open the
door only as needed and for short
periods of time

Publicité

loading