Publicité
Les langues disponibles
Les langues disponibles
CAUTIONS
• No use this product in contact with water or with wet hands.
• Never place or use this product close to heat sources (for instance:
heating).
• No connect this product while it remains rolled, it might set fire.
• Use only this product with enough ventilation and refrigeration.
• If you use this product outdoors, you must use as electrical outlet a IPX4
tigh-base.
• If you use this product outdoors, you must always use a Power Failure
Protection Switch (FI-30mA) between the Power Supplier (220-240V) and the
product.
• Protect all the cables against potential damages.
• The lamps are not exchangable.
• Under no circumstances should you beat this product with a hammer, it
might damage the lamps.
• If the product is mounted to hang freely, it must be adjusted to a steel
cable and be connected to it every 10 cm.
• If the FLEXILIGHT is going to use in permanent installations, you have to
take into account that it will lose progressively performance in white and
blue colors after many continuous hours.
CONNECTION TO THE POWER SUPPLIER
• Do not connect the FLEXILIGHT to the power supplier until the installation
or the modification has been completed.
• Do not connect the FLEXILIGHT to the power supplier until the end cap
has been fixed with security to the edge of the FLEXILIGHT.
• Do not connect the garland to the power supplier while it is in its packa-
ge, unless the package has a decorative meaning.
• Make sure that the power supplier has not a higher voltage that the
FLEXILIGHT.
• It is recommended to use plug/ adapter with fuse in order to avoid any
damages from overload.
CONNECTION.
• Only can be connect between them those FLEXILIGHT with the same
voltage.
• When it is going to make connections between pieces from the FLEXI-
LIGHT, o the FLEXILIGHT with the power cord, make sure that both parts keep
the narrowest as possible.
• The connector pins and the copper wire of the FLEXILIGHT.
• The male and female connector.
• The length of the FLEXILIGHT has not to overcome the maximum power
load (Look the chart with the parametres)
• It is recommended to seal all the connectors with neutral adhesive silico-
ne in order to avoid the entry of moisture in the FLEXILIGHT.
THE CUT
• Cut the FLEXILIGHT exclusively along the crops marks.
• To avoid possible short-circuits, make sure that the copper wire is cut
clearly.
USE
• Warn the FLEXILIGHT by connecting it to the network before giving shape
to the design. Unplug it while you are applying the shape desired.
• Do not use the metal cable, which can be conductive, to tie the FLEXI-
LIGHT.
• Make sure that the FLEXILIGHT does not make contact with any flam-
mable material or that can be melting.
• Ensure that there is an appropriate ventilation around the FLEXILIGHT, do
not cover or install the FLEXILIGHT in an enclosed area.
• Do not dip the FLEXILIGHT under the water.
• Once the installation is planned, it is recommended that qualified staff
check it out.
• Throw away the product in the right place to do so.
YOUR LED FLEXILIGHT WORKS BETTER IF:
• Do not expose it directly to sunlight. UV radiation destroys the PVC cove-
rage of your FLEXILIGHT.
• If it is operated with supply of stable flow, changes in the voltage dama-
ge or shorten the useful life.
• It is used in a neutral chemical environment. Strong acids, alkaline, radio-
active, etc Damage the PVC coverage.
Publicité
