Publicité
Les langues disponibles
Les langues disponibles
1. Please use the card to measure hole positions and drill 2 holes.
2. Fix 2 expansion plugs into the holes.
3. Fix screws to the expansion plugs with a spare space.
4. Hang the notch onto the screws and fasten the lamp.
5. Press the button to turn on the lamp.
Working Modes
120°
120°
Remarks
1. The switch is cut-off switch, which reduce battery consumption and enhance longer storage
time.
2. This lamp can get solar charged in any mode.
3. This is a solar powered lamp, please install it in a location where can get enough sunshine.
4. Please kindly note the lighting time depends on sunshine duration and weather.
5. The lamp will light up automatically at dusk and off at dawn.
6. Built-in IC is with over-charge, over-discharge and over-voltage protection.
7. The lamp is equipped with an internal lithium battery, which is replaceable. If any need,
please contact seller for correct new battery.
8. If the battery is taken out and put back in or replaced with new ones, please toward the solar
panel to sunshine or a strong light to activate the lamp.
9. Non qualified personnel should not disassemble the lamp.
10. Please do not dispose he battery with household garbage to avoid explosion.
When battery capacity >30%, lamp
automatically turns on to full brightness
(220lm) when motion is detected in the
range ≤6Mtrs and then turns to weak
120°
brightness (front light ON & back light on) in
10 seconds of no motion.
When battery capacity <30%, lamp
automatically turns on to full brightness
(220lm) when motion is detected in the
range ≤6Mtrs and then turns to weak
120°
brightness (front light OFF & back light on) in
10 seconds of no motion.
18
Publicité
