Replacing The Filter-Bag - Termozeta Pocket 6000 Mode D'emploi

COMPLETION OF USE
• Press the switch (3) to shut off the vacuum cleaner and
disconnect the plug from the socket.
• Wind up the power cord on the special hooks (13) as shown
in fig. 2

REPLACING THE FILTER-BAG

This operation must be performed with the vacuum cleaner off and with the plug
disconnected from the socket.
When the sensor (4) changes colour it means that the filter-bag is full.
Replace the filter-bag on a regular basis. This will avoid
limiting suction capacity of the vacuum cleaner resulting
in a loss of efficiency. The bag will break when it is too full.
• Press the release button (7) and lift the cover (6).
• Remove the filter bag (8) from its housing (9) by gripping the
cardboard located at the base.
• Insert a new filter-bag in the seat taking care to put it in with
the arrow symbol on the cardboard in front fig.3.
• Close the cover (6).
WARNING!
Make sure that the cover (6) IS CLOSED PROPERLY. If it
sn't, repeat the operation until the cover is properly mounted.
ENGLISH
Fig. 2
Fig. 3