Technical Specifications - ExPelec NICOLS IP WASH 600 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

User manual
1.4 INSTALLATION
The unit should be mounted by its screws holes on the bracket. Always ensure that th eunit is frimly fixed
to avoid vibration and slipping while operating. The structure to which you are attaching the unit should
be able to support 10 times the weight of the unit. Also always use a safety cable than can hold 12 times
the weight of the unti when installing the fixture. The quipment must be fixed by professionals.
The product can be mounted in an upright or sitting position using the supporting brackets.
NOTE:
The product can be mounted at any angle and in any position. It is possible to further adjust the angle of
the product using the two adjustment knobs located on the side of the fixture.
This product is designed for indoor/outdoor use.
1.4 SPECIAL CONSTRUCTION FOR DMX CONNECTION
At last fixture, the DMX cable has to be terminated with a terminator to reduce signal errors. Solder a
120-ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the
DMX-output of the last fixture.
If the controller is 5-pin output, it's necessary to use an adaptor to transfer signal from 5-pin output
to 3-pin XLR-plug or you can connect cables as following:

2. TECHNICAL SPECIFICATIONS

60 x 10 W LED panel RGBW FC IP
* Light Source : 60 x 10 W LED RGBW 4 in 1
* 90 500 LUX@1M
* Noise : 27 dBA@1m
* DMX modes : 6/6/8/10 channels
* Control modes : DMX, Master-Slave, Auto
* Dimming : 0-100%
* Beam angle : 20°
* Strobe : 0-20 Hz
* Tilt manuel : 45°- 145°
* Flicker free
* Voltage : AC100-240V, 50/60Hz
* Power consumption : 420W
* Dimensions: 570×225×270mm
* Net weight 16Kg
IP WASH 600
9

Publicité

Table des Matières
loading

Produits Connexes pour ExPelec NICOLS IP WASH 600

Table des Matières