Dancover Palma Twin Mode D'emploi page 26

Palma Twin Operating Instructions
4.2 Using the Palma Twin in recirculation mode
On the selection switch, select position "Recirculation"
Manual: Plug the Palma Twin - Manual fan heater directly into the mains socket. The Palma Twin will now
run in continuous operation. During the summer months, you can achieve a reduction in the temperature in
the greenhouse by using the recirculation mode. In this operating mode, open the door or the skylight of your
greenhouse.
Digital: First plug the Palma Twin - Digital fan heater into the Thermo 2 and then plug the Thermo 2 into the
mains socket. The Palma Twin - Digital will help you to reduce the temperature in your greenhouse.
In this operating state, open the door or the skylight of your greenhouse.
Please note! In this operating mode, the position of the thermostat switch is irrelevant. The greenhouse air
heated by the sun is constantly circulated in recirculation mode and in this way transported to the outside. At
the same time, this regulates the humidity in the greenhouse and promotes pollination of your plants.
Example:
You want to achieve a maximum temperature of
25°C in your greenhouse. Then take a Palma
Twin + a Thermo 2 and set the temperature at
the Thermo 2 to 25°C. The Palma Twin now
switches on automatically when the temperature
rises above 25°C and runs until the temperature
is below 25°C again.
Switch position plays no
role in recirculation
mode
as the mode. In this mode, there is NO heating.
26
Recirculation switch
EN