Publicité
Les langues disponibles
Les langues disponibles
THANK YOU!
Thank you for purchasing this product. We work around the clock and around the globe to ensure
that our products maintain the highest possible quality. However, in the rare case of issues during
assembly or use of this product, please contact our Consumer Hotline at 800-759-0977 for immediate
assistance before contacting your retailer. Please read the warranty information at the back of these
assembly instructions for further details.
PARTS
1
NGP7428
2
NGP7429
X1
LASER BODY
EVA PAD
Illustrations Not to Scale
ASSEMBLY
STEP 1:
STEP 2:
wall
Adjust Laser Line to 7' 9-1/4" (2.37m) from face of dartboard
ADDITIONAL EQUIPMENT
REQUIRED:
X1
AAA BATTERIES
(NOT INCLUDED)
7' 9.25" (2.37m)
Wavelength:
635nm Max Power 5mW
Class IIIA Laser Product
1. Mount your dartboard or dart cabinet. With one hand
place the Laser Dart Line on the wall or cabinet directly
below and centered on the dartboard. With your other
hand level the Laser Dart Line.
2. Locate the mounting holes and use a pencil to mark
the center of the holes on the wall or cabinet. Drill plot
holes, and use plastic anchors if mounting in drywall.
Insert screws and tighten. Before tightening the screws,
check that the Laser Dart Line is level.
3. Remove the top battery cover and insert 2 AA batteries.
2
Publicité
