Electrical Connection Diagram - Certikin PLQC0800 Manuel D'installation Et D'entretien

The lamp PLQC0800 can be controlled in two different ways: either by a normally closed pushbutton or by means of
the CONTROL BOX and/or remote control
In both cases, you should make sure that the voltage received by the lamp is never more than 12V.
The lamp should only be operated underwater and anchored to the vertical walls of the pool. The lamp is supplied with
heat protection, which in the event of excess temperature reduces the lighting level to avoid overheating.
6.1. PUSHBUTTON CONTROL
The system has 12 operation modes: 6 set colours and 6 sequences of different colours (see section 6.3) The
colour or sequence is changed by a quick press of the pushbutton. The lamp/s is/are placed in white if the pushbutton
is pressed for longer.

6.1.1. Electrical connection diagram

The system is composed of the projector/s, the transformer and the normally closed (NC) pushbutton.
The transformer must be able to supply 45VA for each led lamp connected. For example, if you want to control 5
lamps, you must connect them in parallel to a transformer of at least 225VA. The pushbutton must be able to withhold
the power consumed by the number of lamps installed.
6.2. BOX CONTROL AND/OR REMOTE CONTROL
The system has 12 operation modes: 6 set colours and 6 sequences of different colours (see section 6.3).
The CONTROL BOX controls switching the lamps on and off, changes of colour and sequences and switching off
timing.
If you have a remote control, apart from the CONTROL BOX operations.
6.2.1. Electrical connection diagram
For correct installation, you will need the CONTROL BOX, the transformer and finally the leds lamp. As an option, this
system can be controlled by Remote Control. For more information on the installation of the Receiver-Modulator, see
point 6.2.3. and section 6.2.4. includes information on the Remote Control.
The CONTROL BOX is connected to the 230 Vac mains by means of two terminals indicated MAINS, and to the
primary input of the transformer (230 Vac) by means of the terminals indicated TRF (See attached diagram).
The transformer must have the capacity to supply 45 VA to each led lamp connected. For example, if you want to
control 5 lamps, they should be connected in parallel to a transformer of at least 225VA.
Each CONTROL BOX can control up to a maximum of 15 LED spotlights.
Once the unit is connected, proceed as follows to start-up the projector for the first time:
• Switch on the unit by activating the 230 Vac. at the input of the CONTROL BOX, which will automatically syntonize
with the transformer. The green led of the CONTROL BOX will flash every 2 seconds and the lamp will remain off.
3