Duraflame DFS-750-1 Manuel D'instruction page 6

OPERATING INSTRUCTIONS
TO ACCESS CONTROL PANEL - Open the door to access the control panel.
- POWER
The Power switch supplies power to all of the functions of the fireplace and will illuminate the flame effect.
This switch must be lit for any of the functions to work.
NOTE: Holding the POWER button on the control panel for 10 seconds will disable the heater function.
Re-activate the heater function by holding this button for 10 seconds again. The controls will beep several
times when this function is activated.
- HEAT
Your fireplace consists of a fan-forced wire element type heater. The HEATER switch turns the heater ON
and OFF. This switch must be lit for the heater function to work.
- TEMPERATURE
The Temperature control knob helps regulate the ambient temperature level. The further the knob is
rotated clockwise, the higher the set point temperature. Turning the knob counter-clockwise will lower the
set point temperature.
( + - ) - BRIGHTNESS
Use + - to increase or decrease the flame brightness levels.
WARNING: Turn the power off when servicing this appliance. First turn the main power switch
to the "OFF" position. Then remove the electrical plug from the wall outlet.
-
+
NOTE: Please operate the remote
transmitter at a slow measured pace.
Press the remote control buttons with
an even motion and gentle pressure.
Repeatedly pressing buttons in rapid
succession may cause the transmitter
to malfunction.
Fig. 5
E-5