Jensen 2060LP Manuel Du Propriétaire page 9

Make sure the gas supply is turned to "OFF".
5.
Remove the door and place the tank in the tank
seat divits so that it sits securely and is level.
6. Connect the LP Gas Tank
Before connection, be sure there is no debris caught in the
collar of the LP gas tank, the regulator valve, the burner
tube, or the burner ports.
Connect the gas line to the tank by turning the connection
knob clockwise. Hand-tighten only.
Disconnect the LP Gas Tank
To disconnect the LP gas tank, make sure the valve on the
LP gas tank is completely closed.
Disconnect the connection knob by turning it counterclockwise
until it is detached from the valve.
WARNING
!
If the table is installed with a portion of the hose under
the table, the hose must be secured, so that no part of
the hose will be within 1" or come in contact with the
underside of the burn pan or where the hose will not be
accidentally damaged or pinched.
Failure to secure the hose in a safe location may result in
a gas leak that could cause property damage, injury,
or death. Follow all other hose inspection instructions
listed in this manual.
ASSEMBLY INSTRUCTIONS
Tank Seat
Coil the hose next to the
door for easy inspection.
9
Valve
The hose should not come within 1"
1"
from the bottom of the burn pan.
Do not coil the hose
beneath the valve.