Exposure Marine SUB M3 Guide De Démarrage

- DIVE LIGHT - SUB M3
ENGLISH
DIVE LIGHT SPECIFICATION
An instructional video can be found at www.use1.com/exposure-marine/diving-lights
The Sub M3 design is depth rated to 200m
This light has been pressure tested to 100m/10 Bar for 30 minutes
1 2
There are 2 modes: = Low mode (18 hours)
DIVE LIGHT INSTRUCTIONS
Motion Control Technology (MCT)
This patented technology allows the light to be
controlled without the use of a mechanical switch,
eliminating the risk of water ingress and mechanical
failure. When attached to the wrist mount it allows for
hands free control.
Clockwise and Anti-clockwise circular motions are used
to change mode. A circular motion of diameter less than
5cm and roughly 2 per second will adjust mode most
effectively. It is advised to familiarise yourself with the
motion through entering and exiting travel lock mode
as it allows you to see when a rotation is recognised.
Travel Lock (LOC)
Travel Lock will be entered automatically if the light is not turned on for 1 hour and after charging
Travel lock prevents the light from being turned on accidentally during travel.
To exit Travel Lock
• It is advised to exit travel lock before Diving
• Tap or shake the light - the display will show LOC
• Point the light towards the ground
• Make 3 clockwise continuous circular motions with your arm. The indicator LOC will disappear as
each of the rotations are recognised;
• Clockwise Rotation 0 = LOC
• Clockwise Rotation 1 = LO
• Clockwise Rotation 2 = L
• Clockwise Rotation 3 = OFF = (Standby Mode)
To turn ON
• Point the light in any direction other than down and continuously rotate clockwise
• Clockwise rotation 0 = OFF / CH%%
• Clockwise rotation 1 = OFF 1
• Clockwise rotation 2 = ON 1
= High mode (2 hours)
Rotate in a clockwise or
anti-clockwise motion
For more information please visit www.exposuremarine.com
To change mode
• To increase power to ON 2 rotate clockwise
• To decrease power to ON 1 rotate anti-clockwise
To turn OFF
• From ON 1 point the light towards the ground and continuously rotate anti-clockwise
• Anti-clockwise rotation 1 = OFF 1
• Anti-clockwise rotation 2 = OFF 2
• Anti-clockwise rotation 3 = OFF
To enter Travel Lock (LOC) - the light must be OFF
• Point the light towards the ground
• Make 3 anti-clockwise continuous circular motions with your arm. The indicator LOC will appear as
each of the 3 rotations are recognised
• Anti-clockwise rotation 0 = OFF
• Anti-clockwise rotation 1 = L
• Anti-clockwise rotation 2 = LO
• Anti-clockwise rotation 3 = LOC
Flash or S.O.S
• To turn on Flash from ON 1 or ON 2
Point the light upwards and tap sharply until FLASH mode is activated
•
• To turn on S.O.S from ON 1 or ON 2
Point the light downwards, and tap sharply until SOS mode is activated
•
• To turn either Flash or S.O.S off
Point the light downwards and rotate anti-clockwise
•
• To return to constant mode
Point the torch in any direction and rotate clockwise
•
REAR INDICATION
4 digit display (xxxx) Indicates
LOC Travel Lock
OFF Standby Mode
The battery percentage remaining
CHXX
The battery percentage whilst charging
CHXX ( ashing)
ON 1 Low mode
ON 2 High Mode
Only numbers e.g. 12 04 Estimated remaining battery life in hours and minutes
0.39
1 1 3.89 1 1 .89 13.89