Procedure For Initial Installation - Selve i-R Marki Send Plus Notice D'utilisation

GB

Procedure for initial installation

Procedure for initial installation
Program procedure fort he radio sensor and the i-R Marki Send
Plus:
1. Program the i-R Marki Send Plus in the receiver.
2. Put the receiver in programming mode by pressing the PROG
button of the already programmed i-R Marki Send Plus for
3 seconds. Now the sensory mechanism is programmed in the
receiver by briefly pressing the PROG button on the sensor. Use
the toggle button to check whether programming has been
successful.
i-R Marki Send Plus
3 sec.
Sensor
➡
60

1 sec.