Videotec OHEPS19B Manuel D'instructions page 5

OUT 12Vdc
Fig. 02
Close the housing by proceeding in the
reverse order to that described above.
6.1.2 Installation in VERSO and
VERSO COMPACT housings
Open the housing and place the power
supply (03) in the proper seat.
Fix the power supply to the body of the housing
using the corner support bracket (01) and
the screws (02) provided for this purpose.
Insert the 6 poles connector at the end of
the cable (04) in the corresponding socket
identified by J5, on the support circuit (05).
Connect the power supply to the terminal
identified by J3 on the support circuit (05).
Connect the 12Vdc power supply of the
camera to the terminal identified by J1
(12Vdc, GND) on the support circuit.
IN 100-240Vac
OUT 100-240Vac
04
Fig. 03 Mounting on VERSO housing.
04
Fig. 04 Mounting on VERSO COMPACT housing.
OUT 12Vdc
J1
J5
Fig. 05 Electronic board mounting on VERSO housing.
OUT 12Vdc
J1
J5
Fig. 06 Electronic board mounting on
VERSO COMPACT housing.
Close the housing by proceeding in the
reverse order to that described above.
01
02
03
05
01
02
03
05
IN 100-240Vac
OUT
100-240Vac
J3
IN 100-240Vac
OUT
100-240Vac
J3
3