Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
These
tips
are
specially designed
to clean the pads.
Ref.
A ø
5600
A ø (mm)
B ø (mm)
max. pin ø
(mm)
B ø
Change of desoldering tip
This operation should be done while the tip is hot,
at a minimum temperature of 250°C, so that any
tin left inside is in molten state.
- Unscrew the tip to be replaced, with the aid of
the spanner supplied.
- Fit the new tip, and tighten up with the spanner
to achieve a good air tightness.
DESOLDERING TIPS
5600-011
5600-012
5600-001
5600-002 5600-003 5600-004 5600-005 5600-006 5600-007
001 / 011
002 / 012
1.4
1.8
0.6
0.8
0.4
0.6
Ref. 0780550
5600-013
003 / 013
0 0 4
2.7
3.2
1
1.3
0.8
1.1
To empty the solder tin deposit and change
the filter
For this, the lid needs to be unscrewed and first
the tin deposit and then its spiral must be removed
to clean the inner part of the deposit with a brush.
-
The condition of the filter must be checked
and replaced if dirty or damaged.
-
The deposit needs to be inserted with spiral
filter put into place. Then the whole must be
closed by screwing the lid shut.
6
0 0 5
0 0 6
3.4
4.2
1.6
2
1.4
1.7
Filter Ref.0780840
Spiral
Deposit
Brush
Ref. 0786640
0 0 7
4.8
2.5
2.3
Lid
Publicité
