Black & Decker FSM1616 Traduction Des Instructions D'origine page 6

ENGLISH
• It takes a few seconds for steam to enter the cleaning
pad. The steam mop will now glide easily over the
surface to be sanitized/cleaned.
• Push and pull the steam mop slowly across the surface
to thoroughly steam clean each section.
• When you have finished using the steam mop, return the
handle (4) to the upright position, making sure that it is
supported and turn it 'OFF'. Wait until the steam mop
cools down (approximately five minutes).
Caution! It is important to monitor the water level in the
water tank (3). To refill the water tank and continue to
sanitize/ clean stand the mop upright making sure that the
handle is supported and turn the steam mop 'OFF'. Unplug
the unit from the electrical wall outlet, remove and refill the
water tank (3).
Caution! Never leave the steam mop in one spot on any
surface for any period of time. Always place the steam mop
with the handle (4) supported in the upright position when
stationary and make sure the steam mop is turned off when
not in use.
After use (Fig. E)
• Turn the steam mop 'OFF'. turn the steam operation
button (2) to off and then press the ON/OFF button (1).
• Wait until the steam mop cools down.
• Unplug the steam mop from the electrical wall outlet.
• Empty the water tank.
• Remove the cleaning pad (6) and wash it ready for next
use.
• Clip the supply cable around the cable tidy hooks (7 and
8)
• There is a hanging bracket (10) built into the hand grip
(9) which allows your steam mop to be hung from a
suitable hook on the wall. Always ensure that your wall
hook is capable of supporting the weight of the steam
mop safely.
Technical Data
Voltage V
ac
Power W
Tank
Capacity ml
Weight kg
Troubleshooting
If your appliance seems not to operate properly, follow the
instructions below. If this does not solve the problem, please
contact your local BLACK+DECKER repair agent.
6
(Original instructions)
FSM1616 BDS1616R
(Type 1) (Type 1)
220-240 220-240
1600 1600
350 350
2,3 2,3
Problem Step
The steam mop is not 1.
turning on
2.
3.
The steam mop is not 4.
producing steam
5.
The steam mop is
6.
producing too much
steam during use.
The steam mop is
7.
producing too little
steam during use
The steam mop stops 8.
producing steam
during use
The steam mop stops 9.
producing too little
steam during use
The steam mop is
10.
producing too little
steam during use
Where can I get
11.
further information/
accessories for my
steam mop
Possible solution
Check the unit is
plugged in at the wall
socket.
Check the unit is
switched on using the
ON/OFF switch (1)
Check the fuse in the
plug.
Check the water tank
(3) is full and correctly
Fitted.
Note: When first filled
or after running dry it can
take up to 45seconds for
steam to be produced.
Check the steam
generation button is in
the ON position.
The steam mop has 3
settings. Vary
thumbwheel control dial
(10) to reduce the
amount of steam being
produced.
The steam mop has 3
settings. Vary
thumbwheel control dial
(10) to increase the
amount of steam being
produced.
Check step 1, then 2,
then 3.
Check step 4, then 2,
then 3
Check step 4
Refer to the assembly
chapter of the manual
for correct fitting of
parts and accessories.