UPM WT440 Manuel Du Propriétaire

OWNER'S
MANUAL
Congratulations on your
purchase of this UPM
remote transmitter. This
unit is specifically
designed to work with
UPM Weather Stations.
Please take the time to
read and understand
this manual so you can
begin to enjoy the
convenience and
features this product has
to offer.
FEATURES
Displays and transmits
temperature readings
to the weather station
(in C or F) ° °
RF technology for
reliable wireless
transmission
Low Battery Indicator
Compact design with
wall mount bracket
Drip-proof design
LOW BATTERY INDICATION
WT440 Remote Transmitter
Replace the batteries when the Low Battery Indication lights up on
*
the bottom-left corner of the LCD screen on the WT440H transmitter.
1
NOTE:
After replacing the batteries, you will need to perform the Setup and
Learn Function procedures again. Refer to the GETTING STARTED and
WIRELESS TRANSMISSION sections.
Weather Station Transmitter
WT440
1
WT440 transmitter
PAGE 1
1
*
PAGE 6
GETTING STARTED
Button Placement
1
LCD Screen
2
SET: activates SET function
3
C/F: changes House Code and Channel Code; selects °C
4
Battery Compartment
5
Battery Cover
6
Wall Mount Bracket & Table Stand
1
3
2
1
SET C/F
TROUBLESHOOTING
PROBLEM
The temperature data on the remote transmitter
does not match the data displayed on the
receiver.
The temperature data on the remote transmitter
does not match the data displayed on the
receiver.
The remote (outdoor) readout on the receiver is
blinking.
The remote (outdoor) readout on the receiver is
blinking. The receiver will not detect or receive
the temperature data from the remote transmitter,
even after the Manual Learn Function has been
executed.
5
4
PAGE 2
SOLUTI
This may occur when you move the r
environment to another. For example
transmitter from inside the warm hous
such a case, there will be a big chang
transmitter will record this change in
than it is able to transmit the data to t
once every minute). Therefore, you w
difference in reading between the rem
The solution is to allow the remote tra
its new location to reach equilibrium.
minutes. Once the data is stable, the
remote transmitter should match that
This may also be the result of a temp
to interfering sources. Normal recept
the interference ends. Refer to the W
section.
Re-synchronize the remote transmitte
and holding CHN on the receiver for
heard. The temperature data from th
display on the receiver within 3 minut
TRANSMISSION (Manual Learn Func
Ensure the remote transmitter is away
interference and electrical disturbanc
the remote transmitter in a different lo
receiver. The remote transmitter doe
40 metres, but any walls or windows
will reduce the distance. Due to the n
extreme cold temperatures may also
Refer to the WIRELESS TRANSMISSI
Manual Learn Function with the remo
location.
PAGE 7