Setting The Date And Time - Swann RemoteCam Instructions D'utilisation

Setting the Date and Time

You can setup the RemoteCam to print the date and time that a recording was
taken directly onto the video, like a watermark. To enable this function, you'll just
need to set the time and date - the RemoteCam will keep track of it from there.
To set the Date and Time:
• Open Notepad. It's usually located in the Accessories folder in the Start Menu
(assuming you're using Microsoft Windows
plain text editor will work fine (but not a word processor, and these do not
create plain .txt files).
• Write out the date and time, in the following format:
So, if it was thirty-three minutes past nine in the morning on the fourth of
December 2009, then the file would read:
• Save this file, naming it "settime.txt".
• Copy this file to the microSD card.
• With the microSD card already inserted into
RemoteCam ON.
• The RemoteCam will read the text in the file, and update it's internal clock to
match the date and time as set by you.
Notes:
• The date and time will be updated to the
it is turned on. Before this, the time will not be updated to 'keep up' with
realtime. Thus, if you set the time accurately in the settime.txt file and copy
it to the microSD card, but then leave it an hour before turning on the
RemoteCam, the time stored in the RemoteCam will be one hour behind.
• You may need to reset the time (i.e. go through this procedure again) if the
internal battery in the RemoteCam is completely drained of charge, or you
reset the RemoteCam by pushing the Reset button.
10 10 10
YYYY.MM.DD HH.MM.SS
2009.12.04 09.33.20
RemoteCam's internal clock when
). If you don't have Notepad, any
®
RemoteCam, turn the