Télécharger Imprimer la page

Karcher Design EGF 100 71 Schema De Montage page 2

Publicité

Les langues disponibles

Les langues disponibles

Assembly instruction ‚fixing bolt'
The fixing bolt (EGF 100 71) is already pre-mounted when delivered and
has been designed for thicknesses 8 mm and 10 mm.
Mounting:
1.
Find out the door thickness of the glass door (8 mm or 10 mm)
unscrew M4 counter sunk screw (2)
2.
Adapt the clamping bracket (1) due to the thickness of glass door (8
mm or 10 mm) to the screw hole and screw it, but do not fix it.
3.
Clamp the fixing bolt on the bottom side of the glass door and fix the
M4 counter sunk screw (2). The glass door has to be un-installed.
Please pay attention that the rubber strips (4) on each side are fitted
directly to the glass. The fixing bolt has to clamp strong on the glass
door.
4.
The bottom sleeve (3) has to be adjusted to the fixing bolt and has to
be drilled into the floor. The drilling diameter is 10 mm.
5.
At the end do a functional check.
Glass door thickness 8mm
Glass door thickness 10 mm

Publicité

loading