Danfoss RX1-S V2 Manuel D'installation page 5

Installation Guide
8. Mount back plate direct to wall or on a wall box. The
back plate included within the product packaging
must be used for installation.
9. Locate hooks at top of front part into top of back plate
and lower into position and tighten retaining screw.
2. Dimensions and Wiring
See fig. 4 for dimensions and fig. 5 for wiring diagram on
page 45.
3.1 RF Pairing
1. Ensure power to RX1-S V2 receiver is switched on and
batteries are inserted into thermostat.
2. Put the thermostat in pairing mode, see thermostat
installation guide.
3. Press both PROG and CH buttons on RX1-S V2 until
button LEDs flash.
4. If pairing is successful RF icon on thermostat will stop
flashing and remain on.
5. If pairing is not successful try moving thermostat
to alternative position and retry.
AN30483496955101-000102
EN
RX1-S V2 5