Télécharger Imprimer la page

Danby DAR044A1SSO-6 Manuel Du Propriétaire page 4

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS
LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Prolonged exposure to extreme heat or direct
sunlight may adversely affect the performance
of this unit. Please check the interior temperature
and contents of this unit if extreme heat or
sunlight are present for extended periods.
• This unit is suitable for outdoor use and is
weather resistant. However, it is not waterproof.
Do not use this unit near a swimming pool or hot
tub.
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
• Extreme cold will affect the performance
and reliability of this unit. Do not use this in
environments that are 7°C (45°F) or less.
DOOR HANDLE INSTALLATION
The door handle will ship inside the cabinet to avoid
damage during shipping. It can be installed using
the provided hex key and hexagon bolts found in
the accessory bag.
IMPORTANT
Ensure that the door is fully closed when the
appliance is in operation. Failure to fully close
the door can lead to excessive condensation
and potential water damage to fl ooring under
the appliance. Danby will not be responsible for
damages from misuse.
LEVELING INSTRUCTIONS
There is an adjustable foot on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the adjustable foot counter-clockwise until
the top of the foot is touching the bottom of the
chassis.
2. Slowly turn the adjustable foot clockwise until the
appliance is level.
3

Publicité

loading