Getting Started; Charging Operation; Normal Use Operation; Function - XciteRC XRC M6i Mode D'emploi

Charging operation

First put the power supply switch to OFF position, no LED lights on RF Module
brights the lime, than connect RF Module to a computer (or the other power
EN
supplier equipment) using USB wire, this time, Signal indicator light starts to
flash and Mode indicator light shows charging status: red means charging,
turning to green, means charging is over.

Normal use operation

• Supplying power of radio itself (eg: JR/Futaba) the HT-8 Internal power
supply switch to OFF state. Properly connected HT-8's signal cables and
power cables. (JR signal cable connecting the remote control DSC Interface,
and power cable to connect to DC charging port) (Futaba's connection is a
combination of signal cable and power cable to connect simulator interface)
• IF no power from radio, switch the HT-8 internal power supply to on state.
Properly connected HT-8 and remote control of the DSC Interface.
• Under normal circumstances the HT-8 light is green, when red check the
signal cable if is normal, as well as check the rernote control to set the modu-
lation mode to PPM format. Set the types of remote control through switch
the button of HT-8, the status indicator (Model), Fulaba (green), JR (red),
Walkera (no light).

Function

• Supply internal power, suitable for different brand radio.
• Support main stream radio, such as JR/Futaba/Walkera.
• Charging protection and Low voltage alarm function.

Notice

• There is one 3. 7 V Li-po Battery sealed in the RF Module. If the radio control-
ler you use can supply the power to the RF Module, please turn off the sealed
battery to off status.
• Please pay attention to the battery power when you use sealed battery of
RF Module, if the green light is flashing, please stop to play and charge
the battery.
18

Getting started

50600000 Sendermodul XRC M6i