Publicité
Les langues disponibles
Les langues disponibles
Note: Pressing and holding the increase and decrease temperature
temperature display from °F to °C.
Tip: If you powered the unit o
Warning: Allow at least 24 hours for your beverage cooler to run before storing your beverages and to
allow the temperature to acclimate. Whether your beverage cooler can reach the actual set
temperature depends on the ambient environmental condi ons.
Note: closed.
Note: is restored.
If the interior temperature is higher than 73°F (23°C), "HI" is shown on the display panel and the
Note:
high, and you should look for the reason. If the inner temperature is lower than 32°F (0°C), "LO" is
Internal Light
This cooler is equipped with side internal lights that can be set to Amber, Cloud White or Deep Blue
color. Because the unit comes with a glass door, the inside will be seen whether the door is open or closed.
You can choose to display each color of light in two
Display Mode
The internal lights will stay constantly illuminated whether the door is open or closed.
Auto
Mode
The internal lights will illuminate eac
feature is triggered by a sensor located on the front vent. This sensor allows the cooler to recognize
when the door is open or closed.
To change to between Display
Note: We run test every unit that we produce in our factory. Because of this, your model may default to
any of the abov
your desired light
Tip
Close the door to determine if the light is currently in Display Mode o
:
Mode the lights will remain on,
e wait at lea
the box. Simply cycle through the progression of se
.
o
ve (5) minutes before powering it back on.
ent modes: Display
the door is opened and fade
e, press and hold Light b
9
e will switch the
e door is closed. This
for 3 seconds.
u
ou reach
c Mode. In Display
once the door is closed.
Publicité
