UTC Fire & Security Interlogix Transition Serie Mode D'emploi

Technical support
For assistance with this product, refer to this document and any other
documentation provided. If you still have questions, you may contact technical
support during normal business hours (Monday through Friday, excluding
holidays, between 8 a.m. and 8 p.m. Eastern Standard Time.)
See http://www.interlogix.com/customer-support.
U.S.
1-855-286-8889, option 2
Canada
1-855-286-8889, option 2
Latin America
1-561-998-6114
Web site: http://www.interlogix.com
© 2011 UTC Fire & Security. All rights reserved.
UTC Fire & Security, 9 Farm Springs Road,
Farmington, CT 06034-4065, USA
Description
The T-100 Transition™ Series card reader is a card serial
number reader compatible with the following 125 kHz
Proximity technologies:
®
• CASI ProxLite
®
• HID Proximity
Mounting the reader
1. Find a suitable mounting position on the door frame
or wall.
2. Drill two vertical mounting holes 2.25" (57.2 mm)
apart on the mounting surface of the door frame or
wall.
Figure 1. Dimensions
1.75"
[44.5mm]
4.20
[106.7mm]
front view
3. Drill one 1.00" (25.4 mm) diameter hole in wall for the
pigtail wire connection.
4. Follow the Cable Connection Chart to connect the
reader to the field panel.
5. Mount the base plate to the wall using the supplied
screws.
6. Hook the top of the reader case to the top of the base
plate and press into place.
1.0"
[25.4mm]
side view
Transition Series
T-100 Model Reader
Figure 2. Base plate, reader case, and top cover
7. Install the supplied screw in the base of the reader.
8. Snap the cover on the top of the case.
Connecting the cable
1. The readers are supplied with a 8-conductor cable
pigtail with drain wire. Connect the pigtail to the host
panel. Use the Cable Connection Chart (below) to
correctly match the color of each wire.
Color Signal
Black Ground
Blue Beeper
Brown Red LED Control
Green Data 0
Orange Green LED Control
Red 5 to 16 VDC
White Data 1
Drain Shield Ground
2. Use a DC power source between 5-16 VDC.
3. Connect the reader's drain wire to the cable shield.
Connect shield wires at the field panel.