Publicité
Les langues disponibles
Les langues disponibles
2
3
4
CLEANING
WARNING: Always release pressure from the sprayer
prior to cleaning. Disassembly of a sprayer that is still
pressurized may result in the high-speed ejection of
components.
WARNING: RISK OF PERSONAL INJURY DUE TO
CHEMICAL EXPOSURE. Use the appropriate Personal
Protective Equipment (PPE) as recommended by the
chemical manufacturer and/or refer to the chemical
Safety Data Sheet (SDS) of the chemical being used.
This includes at least goggles, gloves, and protective
clothing.
WARNING: RISK OF DAMAGE TO INTERNAL
COMPONENTS. Failure to properly rinse out the
sprayer may allow chemical residue build-up that
can clog or damage the filters, pump, shut-off,
wand, and nozzle. Chemical residue build-up can
also contaminate subsequent applications. Leaving
chemical liquids in the sprayer when not in use can
lead to premature sprayer wear. Never store the
sprayer with chemicals in any part of the sprayer.
1. Ensure the sprayer is OFF and remove the battery
per the Removing the Battery section.
2. Remove the cap (1) and empty any extra
chemical from the tank into a suitable container
for later use or dispose according to the chemical
manufacturer's instructions.
3. Use clean water to thoroughly rinse and empty
the tank until all chemicals and residues are
removed.
4. Add approximately 1 quart (1 liter) of clean water
to the tank.
5. Insert the battery per the Installing the Battery
instructions and press the Power button (2) to
turn the sprayer ON.
6. Spray water through the pump, hose, shut-off,
1
7. Empty out any remaining water from the tank
8. Press the Power button (2) to turn the sprayer
9. Squeeze the shut-off lever (B) to release any
10. Allow the sprayer to dry. This is best done by
11. Once the sprayer is dried, turn the sprayer
1
3
Battery Pack Cleaning
Remove dirt and grease from the exterior of the
battery using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
Charger Cleaning Instructions
WARNING: Shock hazard. Disconnect the charger
from the AC outlet before cleaning. Dirt and grease
may be removed from the exterior of the charger using
a cloth or soft non-metallic brush. Do not use water or
any cleaning solutions.
wand, and nozzle for at least 30 seconds to rinse
them out. Failure to rinse out these components
may allow chemical residue build-up that can
clog or damage the components. After heavy
use, rinsing the nozzles may not be enough to
remove residue. The nozzles may need to be
cleaned with a small brush.
then continue to spray until water no longer
comes out of the nozzle. This indicates that most
of the water in the system has been removed.
OFF and remove the battery.
remaining pressure in the hose.
removing the cap (1) and strainer basket (3) and
hanging the sprayer upside down to let it drain.
upright and reinstall the strainer basket (3) and
cap (1) to prevent debris from entering the tank.
ENGLISH
B
2
11
Publicité
