Raider RD-TJ03 Mode D'emploi Original page 8

8
vehicle with the jack and remove the supports. Very slowly and carefully turn the valve in the direction
of counterclockwise. Vehicle will rush into your gravity.
5. Maintenance.
5.1. Topping up the hydraulic oil.
Place the jack on a horizontal basis. Remove the black hood covering the top jack. You'll see at
the top of the power cylinder, rubber stopper for filling the hydraulic oil. If the oil level is lower than 12
mm from the edge of the hole, then you must make up hydraulic oil. Recommended hydraulic oil with
viscosity class 10 SAE. After topping up of oil obezvazdushete. (See also item 3.1.).
Be careful during the topping up or changing the oil, it does not fall to dust or other contaminants.
5.2. Lubricated to prevent corrosion.
Piston rod of the power cylinder should be cleaned every three months with a clean cotton cloth
soaked in oil.
5.3. In the storage and prolonged non jack he must descend into extreme down position.
6. Environmental protection.
Hydraulic oil is a liquid that pollute the environment. Operations associated with the valley and
oil change should take measures against the accidental spillage of oil. Do not dispose of disused
hydraulic jacks household waste! In view of environmental protection in the transmission of secondary
raw materials, hydraulic oil to bleed into the office and for processing in accordance with the rules.
Prohibited to discharge of hydraulic oil into drains or open water sources.
All manuals and user guides at all-guides.com