Elta 6695 Mode D'emploi page 17

All manuals and user guides at all-guides.com
02-6695-EN.qxp 10/26/06
MAINTENANCE & SAFETY
PRECAUTIONS & GENERAL MAINTENANCE
• Place the set on a hard and flat surface so the system does not tilt.
• Do not expose the set, batteries or CD to humidity, rain, sand or excessive heat caused by heating equipment or direct
sunlight.
• Do not cover the set. Adequate ventilation with a minimum gap of 15 cm between the
ventilation holes and surrounding surfaces is necessary to prevent heat build-up.
• The mechanical parts of the set contain selflubricating bearings and must not be oiled or
lubricated.
• To clean the set use a soft dry cloth. Do not use any cleaning agents containing alcohol,
ammonia, benzene or abrasives as these may harm the housing.
CD PLAYER AND CD HANDLING
• The lens of the CD player should never be touched!
• Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud
over. Playing a CD us then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the
moisture evaporates.
• Always close the CD door to keep the CD Compartment dust-free. To
clean, dust the compartment with a soft dry cloth.
• To clean the CD, wipe in a straight lien from the center towards the edge
using a soft, line-free cloth. Do not use cleaning agents as they may
damage the disc.
• Never write on a CD or attach any stickers on it.
TROUBLESHOOTING
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
- Problem
• Solution
NO SOUND/POWER
- Volume not adjusted
• Adjust the volume
- Power cord not securely connected
• Connect the AC power cord properly
- Batteries dead/incorrectly inserted
• Insert (fresh) batteries correctly
DISPLAY DOES NOT FUNCTION PROPERLY / NO REACTION TO OPERATION OF ANY THE CONTROL
- Electrostatic discharge
• Switch off and unplug the set. Reconnect after a few seconds
2:26 PM Page 17
17.