Westfalia AH18 Mode D'emploi page 30

charge cycles. This is normal and not a fault with the battery
pack.
Preparation
Before undertaking any adjustments remove the battery from the
machine!
1. Use the rotary switch (2) to set the desired cutting depth of
the planer. The cutting depth can be set from 0 – 1.5 mm
according to the cutting depth scale (1). The depth scale divi-
sion is 0.1 mm
Turning the rotary switch will raise or lower the front planning
sole (13) of the planer. Turn the rotary switch clockwise for
lifting the front planing sole. This will increase the cutting
depth.
Turn the rotary switch counter clockwise for lowering the front
planing sole. This will decrease the cutting depth.
2. Insert the Battery into the battery slot.
3. For safety reasons the electric planer is equipped with a
safety lock-out (5) against accidental activation. First press
and hold either side of the safety lock-out (5). Simultaneously
press the ON/OFF switch (7). Now release the safety lock-out.
Please note that the ON/OFF switch cannot be locked in the
ON position.
4. To turn off the machine, release the ON/OFF switch.
Operation
26