Publicité
Les langues disponibles
Les langues disponibles
INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION
Installing Optional Rear Outlet
Rear outlet kit, 10" boot assembly with register, ROK-1 for warm
air discharge into an adjoining room.
Attention: Before furnace is attached to the wall, the wall opening
for the rear outlet must be cut, in addition to removal of the outer
and inner casing knockouts on furnace.
Note: The privacy shield is not used on the FAW-55(SPP, IP) furnaces
and can be discarded.
1. The wall opening measurements for the rear outlet are the
following.
A. From floor to bottom of wall opening is 14 3/4".
B. From bottom of wall opening to top of wall opening is 8
1/2".
C. Wall opening width is 12 1/8".
2. Remove outer casing knockout from outer casing back.
3. Remove inner casing knockout from inner casing.
Page 2
Empire Comfort Systems, Inc. Nine Eighteen Freeburg Ave. Belleville, Illinois 62222-0529
All manuals and user guides at all-guides.com
INSTALLATION INSTRUCTIONS
REAR OUTLET, KIT NUMBER ROK-1
FAW-55SPP AND FAW-55IP VENTED WALL FURNACES
4. Attach furnace to wall (Refer to Installation Instructions and
5. Align clearance holes on 8" x 12" boot with screw holes on
6. Attach 8" x 12" boot to outer casing back with (6) #8x 3/8" screws
7. Align clearance holes on 6" x 10" duct with screw holes on
8. Attach 6" x 10" duct to inner casing back with (4) #8x 3/8"
9. Insert rear register into 8" x 12" boot. Attach rear register to
10. Installation of ROK-1 is completed.
R-3159
MODELS
Owner's Manual).
outer casing back and mark boot to be flush with wall surface.
Remove boot and cut to proper length.
provided.
inner casing and mark duct to be 2 1/4" shorter than 8" x 12"
boot. Remove duct and cut to proper length.
screws provided.
wall with (2) #10 x 1" screws provided.
R-3159
7/01
Publicité
