Publicité
Installation Instructions
1.
Cut end of cable at angle to aid in piercing grommet.
Leave additional cable for expansion loop.
2.
Insert cable into expediter. If mounted on bottom or side of
pipe, punch out weep hole.
3.
Slide expediter toward pipe and route cable through support
base entry.
4.
Temporarily mount expediter to pipe using pipe band.
Do not band over cable.
5.
Cut off end of cable.
6.
Terminate cable with appropriate PETK termination kit.
Refer to PETK installation instructions.
7.
Remove expediter from pipe by removing pipe band.
8.
Route thermostat bulb through expeditor opening in junction
box base. If necessary, apply lubricant (user supplied) to end
of thermostat bulb. Slide through conical grommet hole.
Push excess capillary tube through expeditor.
2
Publicité
