CANARMNA CQ005 Guide De Dépannage

A). SAFETY PRECAUTIONS
1. WARNING, HIGH VOLTAGE: Disconnect source of electrical power by removing fuse or switching off circuit breaker. Household electrical
power can cause serious injury or death.
2. Electrical wiring must meet all local and national electrical code requirements. Do not use with solid state fans.
3. Electrical source and fan must be 115/120 volt, 60Hz. Maximum fan motor 1.25 amps, maximum light(s) (if applicable) 300W - incandescent
only.
B). INSTALLATION
If other fan or supply wires are a different colour, have the unit installed by a qualified electrician.
1. WARNING: Before operating remote, make sure the fan speed switch is set to "HI".
2. Remove electrical power from the circuit.
3. Remove ceiling fan canopy from the mounting bracket.
4. Make the following wire connections to the receiver unit (see fig. 2) using the marretts supplied
- connect GREEN fan wire to BARE (ground) wire
- connect BLACK or RED (ACL) receiver unit wire to black supply wire (ACL)
- connect WHITE or RED (ACN) receiver unit wire to WHITE supply wire (ACN)
- connect WHITE receiver unit wire (MOTOR N) to WHITE fan wire
- connect BLACK receiver unit wire (MOTOR L) to BLACK fan wire
- connect BLUE receiver unit wire (FOR LIGHT) to BLUE light wire
5. LEARNING PROCESS
- After installing the unit and power on, open battery cover (with battery, DC1.5V/ AAA*2pcs,
not included), use a ball pen to press and hold the "LEARN" key 1~3 seconds. FAN will be turn
off and then FAN turn ON at medium speed, which indicate that learning process finished.
Please note that must press the "LEARNING KEY" within 30 seconds after power on. If just replac
batteries, no need to re-learn.
- Please note that the transmitter can learn multiple receiver, when doing learning process
please make sure not to
LIGHT FUNCTION SELECT SWITCH
- If you install an energy savings bulbs such as a fluorescent in your ceiling fan, slide the function
switch to " O" position and if a regular incandescent bulb
slide switch to the "DIM" position.
6. Push all connected wires up into junction box.
7. Put the receiver in the mounting bracket (see fig. 3).
8. Reinstall the canopy on the mounting bracket.
C). OPERATION
FUNCTIONS OF TRANSMITTER
HI: Turn on the fan at high speed
MED: Turn on the fan at medium speed
LOW: Turn on the fan at low speed
OFF: Turn off the ceiling fan.
LIGHT ON/OFF: Press and release immediately to turn on or off the light
DIMMER- Press and hold to dim or brighten lights to the desired level and
release. (Incandescent light bulbs
• Fan "speed" switch set to "HI" • Power to wall switch? • Switch wired correctly? • Power to receiver? • Receiver wired correctly?
• Code set at exact same positions in both transmitter and receiver ("Hand-held Remote" only)?
• Good battery in remote ("Hand-held Remote" only)? • Light kit switch is turned on ("Hand-held Remote"and "Wall Switch"only)?
Imported by: 2157 Parkedale Avenue, Brockville, Ontario K6V 5V6 •
CEILING FAN CONTROLS
learn from other receiver.
or dimmable LED bulb
TROUBLE SHOOTING GUIDE
or a dimmable LED bulb is used, then
only.)
PH: 1-800-265-1833 • FAX: (613) 342-8437
Figure 1
LEARN
O/ DIM
LIGHT FUNCTION
SELECT SWITCH
Figure 2
RECEIVER
WHITE OR
RED (AC IN N)
BLACK OR
RED (AC IN L)
WHITE WHITE
BLUE BLUE
BLACK
BLACK
FAN
Figure 3
CQ005
04/19
GREEN