Ferplast bluskimmer 250 Manuel D'utilisation page 8

BLUSKIMMER
Installing
BLUSKIMMER is quick and easy to install:
1 Position the product inside the tank, taking
care to ensure that the intake and outlet grilles
are not close to elements that could in any way
limit the suction or flow capacity; the magnet
outside the tank allows the product to be
fixed safely (CAYMAN aquarium Fig. 2, STAR
aquariums Fig. 3);
2 the collection tank must always remain above
the water level;
3 the silencer must always remain outside the
tank (to fix it use the special sucker);
4 adjust the vertical position of the skimmer
using the magnet outside the tank and lining
up the water level with the recommended level
"water level" shown on the product (Fig. 4);
5 connect the product to the mains;
6 for the first installation, the skimmer needs
about 24-48 hours to reach its operating
balance;
7 if at first you notice excess foam production,
reduce the air flow using the regulator on the
silencer (Fig. 7); only later should you try to
increase the air flow, returning, if possible, to
the maximum level;
8 once it is fully operating, you can make small
adjustments to the foam production by moving
the skimmer vertically (with a total maximum
range of about 1 cm) (Fig. 4) downwards if
there is too little foam produced or if the foam
is too dry and upwards if too much foam is
produced or it is too wet;
9 for prolonged absences, you can connect a
pipe to the excess dirt nozzle (after removing
the plug), in order to allow discharge into a
container outside the tank (Fig. 6).
Fig. 4
WATER LEVEL
8
English
0,5
TOT
1 cm
0,5
INSTALLATION IN A CAYMAN AQUARIUM
• In a CAYMAN aquarium (excluding models 40
and 50) the skimmer can be positioned in
the special compartment, after appropriately
removing the cover and cutting the plastic, as
shown in the picture (Fig. 2).
• before opening the lid, always remember to
!
remove the collection tank.
INSTALLATION IN A STAR AQUARIUM
• In a STAR aquarium, the skimmer can be
positioned in line with the rear grilles, after
appropriately removing them and introducing
the collection tank; in some previous versions of
STAR aquariums the grills are not positioned to
let the collection tank pass through, therefore
it is necessary to cut the aluminium (Fig. 5);
• before opening the lid, always remember to
!
remove the collection tank.
Fig. 2
Fig. 3
Fig. 5
~
11 cm
~
6 cm