Publicité
Les langues disponibles
Les langues disponibles
For a perfect finishing:
Slightly sweeping manually with a dry wiping cloth will allow you to remove all wet remaining traces. Indeed,
depending on the methodology of each user, a few residual traces of water can remain, you just have to wipe
them with a dry piece of linen, your windows will always be clean and the traces of grease will be completely
removed after the passage of your device.
An excessively dirty water in the tank can be at the origin of residual traces, after drying, it is recommended to
change the water of the tank after each use and sometimes during the cleaning of especially dirty surfaces.
The wiping cloths must also be regularly changed, depending on their dirt state.
General security instructions:
This appliance is meant for domestic use only.
This appliance is not made to be used by persons whose physical, sensorial or mental abilities are reduced
(children and teenagers included), or by persons without any experience or knowledge, except if they could
have supervision or preliminary instructions for use of the appliance by somebody responsible for their
security.
Children should be supervised to ensure that they do not play with the appliance.
In dangerous places with explosion risks, the use is forbidden. Do not place the appliance near a source of
heat, never plunge the appliance in water or any other liquid.
Never leave the appliance plugged in without any supervision.
Never leave the packaging (plastic bag, polystyrene...) next to children, those are sources of potential
danger.
Only plug in the appliance on a ground connection, and whose voltage is complying with prescriptions of the
manufacturer, written on the identification plate displayed on the appliance.
Only use the wiping cloth of origin, supplied with the appliance.
After use and before user maintenance, always disconnect the appliance from the mains
To avoid any risks of electric chocks, do not dismantle or try to repair yourself the appliance.
If the power cord is damaged, it must be replaced by the manufacturer, its customer service or similarly
qualified professionals to avoid hazards.
In case of damage or break-down, you must get in contact with your supplier, or with an authorized technical
centre.
A bad assembly or repair could lead to an electric chock to the user.
You must not dismantle the appliance yourself, in any case, or the guaranty may not be any more
valid.
Be very careful when using this appliance, the production of vapour is very hot, 90°C to 100°C.
CAREFUL – Risk of scalding!
USE (carefully read this explanatory leaflet)
Filling up of the tank
-
1 disconnect the tank (2) from the main body (1) pressing on the clip (3) and pulling the tank towards
the bottom.
-
2 open the water tank cap (4) by pulling
-
3 fill up the tank with a 0.3 litre capacity, directly under the tap.
-
4 make sure the filter (5) is well set behind, and closed with the stopper/top.
-
5 check that the 4 little round joints (6) are always in place.
-
6 set the tank back (2) under the main body (1) taking care of placing the narrow strips (7) opposite
the slots (8), then clip the whole.
Never place the appliance under the tap for the filling up of the tank.
Setting of the micro-fibre wiping cloth
-
7 place the scraping joint (11) opposite you
-
8 set the wiping cloth taking care of placing the tube (12) exactly under the joint, tube set towards the
outside (picture 11) in relation to the wiping cloth so it can keep its mobility regarding the squeezing of
the joint, the wiping cloth must be perfectly set, and laterally to equal distances.
-
9 with the help of your fingers slip the upper strip (13) between the joint and the vapour exit.
-
10 insert the lower part of the wiping cloth (14) with the help of a finger between its support and the
shell of the appliance. Folding in two this low part of the wiping cloth during the operation can ease its
All manuals and user guides at all-guides.com
Publicité
