Publicité
Les langues disponibles
Les langues disponibles
ENERGY-SAVING TIPS
Install the fridge or freezer in a cool place out of direct sunlight
and away from cookers, heaters, dishwashers or any hot air
emitting items�
Do not set the fridge and freezer temperatures lower than
necessary� Set the internal temperature within the correct range
e�g� adjust the thermostat at middle position for 4°C in the fridge
compartment and -18°C in the freezer respectively�
Let pre-cooked foods cool down before placing them in the fridge
GB
or freezer� This will prevent the internal temperature of the fridge
from rising�
Keep your fridge full, but not over crowded, this helps reduce
"cold" air loss� Meanwhile, avoid overloading the fridge or
freezer� Try to leave about 20% free space for air circulation�
To prevent cold air escaping, limit the frequency of opening door�
When retuning from shopping, sort foods to be kept in your
fridge before opening the door� Only open the door to put food in
or take it out�
Make sure the door seal is clean and in good condition� It should
hold a piece of paper tightly in place when shut�
Defrost regularly or when ice is more than 5mm thick� Thick ice
covering the inner sides significantly increases energy use�
The combination of the drawers, baskets and shelves shown in
the device description is optimal for efficient energy savings�
Changing the combination proposition could alter the efficiency�
42
Reverse door
This refrigerator can be opened either from the left or right side�
The default way of opening the door is from the right side� If
you want to open the door from the left side, please follow the
instructions below�
Tools Required: Phillips style screwdriver / Flat blated
screwdriver / Hexagonal spanner
• If you want to have the door swing reversed, we recommend
that you contact a qualified technician� You should only try to
reverse the door yourself if you believe that you are qualified
to do so�
• Ensure the unit is unplugged and empty�
• Adjust the two levelling feet to their highest position�
• To take the door off it is necessary to tilt the unit backwards�
You should rest the unit on something solid so that it will not
slip during the door reversing process�
• All parts removed must be saved to do the reinstallation of the
door�
• The refrigerator inclination angle should be less than 45°�
• Do not lay the unit fat as this may damage the coolant system�
• You should rest the Appliance on something solid e�g� a chair
just below the top panel�
• We recommend that 2 people handle the unit during
assembly�
GB
43
Publicité
