Publicité
Les langues disponibles
Les langues disponibles
Fully automatic spindle locking (Auto-lock)
When the On/Off switch (3) is not pressed, the drill
spindle and thus the tool holder are locked.
This enables screws to be screwed in, even when the
battery is empty and allows for the tool to be used
as a screwdriver.
Run-on Brake
When the On/Off switch (3) is released, the chuck
brakes to a stop, thus preventing the run-on of the tool.
switch (3). By doing so, the head of the screw does not
penetrate into the material.
Operating Instructions
Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
Soft Grip
The gripping surface (2) reduces the danger of slipping
and thereby improves the grip on the tool and the
handling.
At the same time, the rubber coating achieves a
vibration-reducing effect, for an increased comfort for
the operator.
Screwdriving operation
First, slide the action mode change lever to the position
of
symbol and select the fastening torque.
Place the point of the driver bit in the screw head and
apply pressure to the tool.
Start the tool slowly and then increase the speed
gradually. Release the switch (3) as soon as the clutch
cuts in.
CAUTION
• Make sure that the driver bit is inserted straight in the
screw head, or the screw and/or bit may be damaged.
• When driving wood screws, predrill pilot holes to make
driving easier and to prevent splitting of the work piece.
See the chart below.
• If the tool is operated continuously until the battery
pack has discharged, allow the tool to rest for 15 minutes
before proceeding with a fresh battery.
Drilling operation
First, slide the fastening torque the position of symbol ' '.
All manuals and user guides at all-guides.com
then release the On/Off
Drilling in wood
When drilling in wood, the best results are obtained
with wood drills equipped with a guide screw.
The guide screw makes drilling easier by pulling
the bit into the work piece.
Drilling in metal
To prevent the bit from slipping when starting a hole,
make an indentation with a center-punch and hammer
at the point to be drilled. Place the point of the bit in the
indentation and start drilling. Use a cutting lubricant
when drilling metals. The exceptions are iron and
brass which should be drilled dr y.
CAUTION
a) Pressing excessively on the tool will not speed up
the drilling. In fact, this excessive pressure will only
serve to damage the tip of your bit, decrease the tool
performance and shorten the service life of the tool.
b) There is a tremendous force exerted on the tool/bit
at the time of hole break
the work piece.
c) A stuck bit can be removed simply by setting the
reversing switch to reverse rotation in order to back
out. However, the tool may back
d) Always secure a small work piece in a vise or similar
hold down device.
e) If the tool is operated continuously until the battery
pack has discharged, allow the tool to rest for 15
minutes before proceeding with a fresh battery
MAINTENANCE
Cleaning and Maintenance
CAUTION!
!
1) Place the reversing switch lever (3) into the middle
position before carrying out any tasks on the tool,
e.g. changing bits or maintenance, or before
transporting or storing
Tips for maintaining maximum battery life
1)
Charge the battery pack before it is completely
discharged.
Always stop tool operation and charge the battery pack
when you notice a decrease in tool power.
2)
Never recharge a fully charged battery pack. Over-
charging shortens the battery service life.
3)
Charge the battery pack with room temperature at
0
0
0
10
C-40
C (50
F-104
cool down before charging it.
4)
Charge the Nickel-cadmium battery pack when you
do not use it for more than six months.
12
0
F) and let a hot battery pack
Publicité
