Genius TRIO RACER Mode D'emploi page 2

A. Button Assignment:
B. Assembly
You have two methods to install the steering wheel. Please choose one and follow the directions.
1. Play on desk or table
① .
Connect the clamp to the base of the steering wheel as shown in Figure 1 below.
② .
Place the TrioRacer Wheel in a comfortable driving position (on a desk or table) and press the base
unit down firmly on the surface. (See Figure 2)
③ .
Turn the clamp screw until the base is firmly connected. (See Figure 3)
2. Play on your thighs
① .
Unpack the thigh attachments.
② .
Turn the Wheel upside down and locate the assembly pinholes.
③ .
Insert the thigh attachments into the assembly holder on the bottom side then put the wheel on your
thighs as shown in figure 4.
How to take apart the attachments:
Slip out the thigh attachments as shown below.
C. Installation
1.
For PC
Hardware installation
① .
Connect the pedals to the steering column.
② .
Connect the power adapter cable to the steering column.
③ .
Connect the USB plug to the USB port of the PC.
Note: Do not connect the steering wheel to a USB hub. It only works when it is connected directly to the
USB port of the PC.
Driver installation
① .
The wheel has to be connected to the PC first. Then insert the driver CD into your CD-ROM drive.
② .
If the installation program does not start automatically, click on "Start/Run/Browse" and select your
CD-ROM drive.
③ .
Double click on the file "setup.exe"
LED
L2
L1
L2
Dire ct ional
Pad
MODE
Figure 1
R 1
Brake
R2
R 2
SELEC T
S TART
Figure 2
1
English
Gas
Figure 3
Figure.4