Philips HD7452 Manuel De L'utilisateur page 8

EnglisH
8
Note: Some versions come with a permanent filter. In this case you do not need to use paper filters.
6 Put ground coffee (filter-fine grind) in the filter (Fig. 13).
- For large cups: use one heaped measuring spoon of ground coffee for each cup.
- For small cups: use one level measuring spoon of ground coffee for each cup.
7 Close the lid of the coffeemaker. (Fig. 7)
8 Place the jug with the lid closed on the hotplate (Fig. 8).
Note: Make sure you put the jug on the hotplate with the spout facing into the appliance. If the spout of
the jug sticks out from under the filter holder, the coffee may cool down.
Note: If you do not place the jug properly on the hotplate, the drip stop prevents the coffee from flowing
into the jug. This may cause the filter to overflow.
9 Press the on/off switch to switch on the appliance (Fig. 9).
, The power-on light goes on.
10 Let the water pass through the filter into the jug.
Note: If you want to remove the jug during brewing, the drip stop prevents coffee from dripping through
the filter onto the hotplate. Place back the jug as soon as possible to prevent the filter from
overflowing (Fig. 14).
11 You can leave the jug on the hotplate to keep the coffee warm and to preserve its flavour.
Note: Make sure you put the jug on the hotplate with the spout facing into the appliance. If the spout of
the jug sticks out from under the filter holder, the coffee may cool down.
12 After use, press the on/off switch to switch off the appliance.
Note: The appliance does not switch off automatically.
Note: If you want to brew another jug of coffee right away, let the appliance cool down for 3 minutes
first.
13 Remove the filter holder and throw away the paper filter and its contents. If you have used
the permanent filter, empty and rinse it.
Tip: After the brewing cycle is completed, you can pour the hot coffee into a thermos jug to keep it hot
and fresh.
cleaning
Never immerse the appliance in water or any other liquid, nor rinse it under the tap.
1 Unplug the appliance and let it cool down.
2 Clean the outside of the appliance with a moist cloth.
3 Remove the filter holder.
4 Remove the water tank cover (Fig. 15).
5 Remove the lid from the jug.
6 Clean the filter holder, the water tank cover, the jug and the lid of the jug in hot water with
some washing-up liquid or in the dishwasher.
7 After cleaning, rinse the jug with fresh hot water and reattach all parts.
- For instructions on how to reattach the water tank cover and filter holder, see chapter 'Before
first use'.
All manuals and user guides at all-guides.com